MachineLogic - Simulate your design in CAD
Once you have completed your design in MachineBuilder, try simulating your automated equipment using MachineLogic. This allows you to validate the operation cycle, correct the placement of sensors, and utilize a code-free program (MachineLogic) on your MachineMotion controller to operate your equipment.
To run MachineLogic, ensure you have the following components in your design:
- MachineMotion controller https://vention.io/parts-library/search/controller (CE-CL-005-0003)
- An actuator https://vention.io/parts-library/category/linear-motion
- A gantry plate https://vention.io/parts-library/category/linear-motion/gantry-plates
- End-stop sensors https://vention.io/parts/m18-inductive-proximity-sensor-sn-10-mm-244 (CE-SN-004-0001)